Meidad

the ADAM is a 5510 EKW, the problem is i can't enter to drive c:, i need know a way to break the routine of boot, or  maybe there is a way to reset the memory.

The Adam Every time start, stay block.

The picture shows what is the adam doing.

Meidad

Hey what's up with the forum, what can i do with my problem.

Please help me.

shaoyi.wang

Hello Sir,

Please use the attached program READRTC.exe to read the RTC data.
If the last two bytes data is not 1b 94, please update the RTC data.



The program fixRTC.exe is to write the correct RTC data.
Please run the program in DOS command line.
PS. You could format the D drive in initial mode and copy the programs to it.
Hope it could help you.

[ Last edited by shaoyi.wang at 2008-7-21 19:04 ]

ss.lin

The AX8796 is a socket driver for adam-5510ekwtp.But the machine on user hand is adam-5510kw without Lan port .
So he put the wrong  files in disk D. That's why the machine boot again and again .

press ctrl+c can stop the booting .

Please send the correct files to disk D for adam-5510kw .

ss lin

dinhtran

Hi shaoyi.wang,

I had load wrong file to ADAM-5510EKW/TP


I run RAEDRTC.EXE in DOS command line and had result:


I run fixRTC.EXE in DOS command line and had result:


Pls help me!

BeerBear

It seems strange .Have you transfered the exe files to 5510kw disk d :   ?

Beer Bear

Jason.Ng

How about Init mode? If you jumpered the Init terminal to ground and still unable to access the D or C drive, eg in DOS prompt all the key stroke is not responding) Then you need to RMA it.

dinhtran

Dear Jason.Ng!

I jumpered the Init terminal to ground, reset ADAM-5510EKW/TP and still unable to access the D or C drive.
In DOS prompt all the key stroke is not responding.
I run RAEDRTC.EXE and fixRTC.EXE by using cmd.EXE.

What is RMA.

Bandit

RMA = Return Merchandise Authorisation,

Or in other words - send it back for repair.

Regards,

Bandit

fabrice_ithpp

Hello,

I had been use checkkw on ADAM5510EkW/TP and the value are below:

Addr: 78, Data=00
Addr: 79, Data=00
Addr: 7A, Data=00
Addr: 7B, Data=00
Addr: 7C, Data=00
Addr: 7D, Data=00
Addr: 7E, Data=1b
Addr: 7F, Data=b4

I'm not able to program this device with multiprog but I can access it with adam.net and ping works.

Can you help me?

Regards,